___________________________________________________ ___________________________________________________ ________________________ 1 of 2 sl power electronics corp ? 6050 king drive ventura, ca 93003 ? phone 805.486.4565 ? fax 858.712.2040 ? email: info@slpower.com ? www.slpower.com specifications specifications ac input 90-264vac, 47-63 hz single phase mtbf > 100k hours (calculated, 25 c at full load) input current 90vac: 2a, 180vac: 1.0a hold - up time 16.7 ms min. @ 110vac inrush current inrush current protection provided overvoltage protection latching input fuse internal primary current fuse provided overload protection > 120% of full rated load, hiccup mode earth leakage current input-gnd: <3.5ma, normal state output-gnd: <0.25ma, normal state short circuit protection hiccup mode, auto-recovery efficiency 88% typical overtemperature protection latching no load powe r <0.5w output voltage see chart input harmonics meets iec61000-3-2, class d safety standards iec/en/ul60950 transient response 5ms return to within 1%, 50% load step. 0.2a/se c slew rate. maximum deviation is 5% topology two-stage conversion and quasi-resonant flyback line / load voltage regulation line: +/-2.0% max., load: +/-5% max isolation input-output: 3000vac, input-g nd: 1500vac, output-gnd: 500vdc minimum load not required operating temperature 0 to 40 c with no derating ripple and noise 1% pk-pk max., 20mhz bw, differential mode temperature coefficient 0.3% per c, maximum turn - on time 3 sec. maximum @ 115vac storage temperature -20 c to +85 c case material black 94v-0 rated polycarbonate relative humidity 5% to 95%, non-condensing case dimensions / output connections see chart and outline drawing altitude 0 to 10,000 ft, operating; -500 to 40,000 ft, non-operating model "a" = original configuration product fam ily : "c" = com m ercial/ite/industrial, "e" = external, "nt" = new technology output pow er: "120" = 120 watts # of outputs "1" = single output "01" = standard. "02" and higher indicates a m odif ied m odel. model output voltage: "09" = 9vdc, "12" = 12vdc, "24" = 24vdc, etc. input connector: "f" = iec320 c14 grounded, other options available, see below output connector: "51" = 6 pin molex. other options available. model number key vv 51 cent 01 1 120 a f CENT1120 universal 120 watt series ite switch-mode power supply 3 year warranty ? universal input 100vac ? 240vac ? single output models up to 120w ? desktop style/non-vented case ? efficiency level iv ? power factor correction ? certified to ul/ en60950 ? ipx1 rated enclosure ? complies with emi/rfi regulations ? modified and custom designs available
___________________________________________________ ___________________________________________________ ________________________ 2 of 2 sl power electronics corp ? 6050 king drive ventura, ca 93003 ? phone 805.486.4565 ? fax 858.712.2040 ? email: info@slpower.com ? www.slpower.com output parameters model number output volts output current (max) max watts ripple (vp-p max) CENT1120a0951f01 9v 9.00a 81w 90mv CENT1120a1251f01 12v 9.17 a 120w 120mv CENT1120a1551f01 15v 7.33 a 120w 150mv CENT1120a1851f01 18v 6.67 a 120w 180mv CENT1120a2451f01 24v 5.00 a 120w 240mv CENT1120a4851f01 48v 2.50 a 120w 480mv note: ripple and noise is measured with 0.1 f ceramic and 10 f electrolytic capacitor in parallel, connected at the measurement point. input receptacle output connector (1 2v model) output connecto r (all other models) iec320, c14 ? class i ?#3? connector is 2.5 mm barrel type, center (+) ?#51? connector is molex 39-01-2060 or equivalent . data sheet ? 2010 sl power electronics corp. the i nformation and specifications contained herein are believed to be correct at the time of publication. rev. 12-3-2010 however, sl power accepts no responsibility for con sequences arising from reproduction errors or inacc uracies. specifications are subject to change with out notice. conducted emissions en55022 class b radiated emissions en55022 class b, fcc part 15, class b. static discharge immunity en61000-4-2, 6kv contact discharge, 8kv air dischar ge radiated rf immunity en61000-4-3, 3v/m. eft/burst immunity en61000-4-4, 2kv/5khz.. line surge immunity en61000-4-5, 1kv differential, 2kv common-mode conducted rf immunity en61000-4-6, 3vrms power frequency magnetic field immunity en61000-4-8, 3a/m, performance criteria a voltage dip immunity en61000-4-11, 70% ut for 10ms, 40% ut for 100ms, <5 % ut for 5000ms, performance criteria a, b line flicker en61000-3-3 line frequency harmonics en61000-3-2, class d CENT1120 universal 120w series ite switch-mode power supply 3year warranty emi/emc compliance 1800+/- 50mm (1000mm on 12v models) outline drawing (#51 connector shown) 167 (6.6?) 40 (1.6?) 82 (3.2?)
|